![]() MOUNTING THE REMOTE SENSOR AND THERMOMETER When replacing batteries for a Remote Sensor, remember to clear the corresponding channel of the Thermometer in this way:ġ.Remove batteries from the remote sensor (step 2 of installing batterie)Ģ.Select the channel that you would like to clear by pressing the CH button on the Thermometer until this channel number is displayed.ģ.Hold the CH button for 3 seconds to clear the channel NOTE: Registered channels will be erased when the batteries of the Thermometer or Remote Sensor are removed. SPRINGFIELD PRECISE TEMP 433MHZ MANUAL 91756 CODEThe thermometer uses random security code technology-it will learn the random code of the first Remote Sensor it detects and log in as channel 1. When first installing, always insert batteries into the Thermometer first, then into the Remote Sensor. Add-on remote sensors can be purchased separately and are compatible with the GE Wireless Thermometer/Clock (model GE5805WS4) as well as this unit. The thermometer can monitor up to two different Remote Sensors on two separate channels. Make ure that the battery cover is fully on and tightened to assure a watertight seal. However, you can also press the small button in the battery compartment (labeled Tx) to register the Remote Sensor to the Thermometer immediatelyĥ.Replace battery cover and tighten 4 battery screws. Replace battery cover.Ģ.Loosen 4 screws on rear battery cover of the Remote Sensor and slide battery cover off.Ĥ.After batteries are installed, the remote sensor will begin transmitting and automatically register to the Thermometer ![]() IMPORTANT :Read the section SETTING UP THE THERMOMETER before installing the batteries for the first time.ġ.Remove the rear cover of thermometer. Min/Max.displays Min or Max temps recordedĬH(Channel).changes displayed channelĬlear.clears memory in Min/max displayĬ/F.Toggle between Celsius ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |